4" Uniball Suspension Lift Kit - 2009-2018 Dodge Ram 1500 4WD (Excl. Mega Cab / Air Ride suspension)

• 34106 - Uniball 4" Suspension Kit WITHOUT Shocks
• 34106KN - Uniball 4" Suspension Kit With (2) Rear SX8000 Nitro Shocks

Give your brand new Ram 1500 a new look with this Tuff Country 4" lift kit. This kit will allow for up to 35" tires. Included in this kit are front and rear upper coil spring spacers, strut spacers, uni-ball upper control arms, front sway bar brackets, front bump stops and relocation brackets to lift the front end of the Ram 1500.

• Custom fit for the Dodge Ram 1500
• Upper control arms w/ uni-ball joints for added stability and control
• front and rear coil spring spacers
• Allows use of 35" x 12.5" tires
• Does not fit 2wd models

• Factory rear shocks must be replaced with new extended shocks to install this lift kit properly. Please choose shocks & boots above if you have not already purchased extended shocks.
• Rims with backspacing of 5.5" or less are required for installation of tires wider than stock width.
• Excludes "Rebel" models.
• Will not fit with rear air ride suspension.
• Will not 3.6 V6 models.
• Will not Megacab models

2) Front upper coil spring spacers, 2) Strut spacers, 2) Uni-Ball upper control arms, 2) Front sway bar drop brackets, 2) Rear coil spring spacers, 2) Front bump stops, 2) Front bump stop relocation brackets 1) Hardware Bag

The Tuff Country Toyota Tacoma 3” suspension lift kit offers an additional tire clearance to fit 32” tires. The kit includes Upper coil spring/strut spacers that lift the front of your vehicle and maintains the factory ride, cast iron blocks which lifts the rear of your vehicle. Note: You do not need to replace your existing factory struts. Tuff Country has been producing quality suspension products for over 20 years and backs all lift kits with a limited lifetime warranty.

• Upper coil / strut spacers maintain a near factory ride
• Front stock struts can be retained
• Rear cast iron blocks
• Allows use of 32" tires
• Rear stainless steel brake hose included

• Factory front & rear shocks must be replaced with new extended shocks to install this lift kit properly. Please choose shocks & boots above if you have not already purchased extended shocks.

2), Front strut spacers, 2) Front strut pre-load spacers, 6) Strut studs, 1) Rear brake line & bracket, 2) 3" cast iron rear lift blocks, 4) Rear ubolts, 2) Differential drop sleeves, 1) Hardware bag

Alternate Part #: 34106KN